October 26, 2026
1000-hour vs. 100-hour dead fuel moisture: what each one tells a burn boss

A RAWS station spits out six moisture numbers a day and most of them don't matter for the decision in front of you. The two that carry the most weight in a prescription are 100-hour and 1000-hour dead fuel moisture, and they're not telling you the same thing. Mixing them up, or reading them as interchangeable, is how a burn boss ends up surprised by holdover smoke or a flare-up in the big down material three days after the crew pulled out.
Time-lag classes are a stand-in for stick diameter, nothing more. A fuel's time-lag is roughly how long it takes to lose about two-thirds of the difference between its current moisture and equilibrium moisture content, given steady weather. Smaller fuels equilibrate fast. Bigger fuels equilibrate slow. That's the whole idea, and it's why the two classes answer different questions on your prescription.
100-hour fuels: your short-window read
100-hour fuels are roughly 1 to 3 inches in diameter, branchwood and small downed limbs. They respond to weather over about a four-to-ten-day span, which makes them the number you lean on when you're deciding whether this week's window is going to hold.
A string of dry, windy afternoons will pull 100-hour moisture down fast, sometimes faster than the long-range RH forecast suggests it should. If 100-hour is dropping into the low teens while your prescription calls for mid-teens minimum, that's your cue that the burn day you circled on the calendar is heating up faster than the forecast implies. This class also moves most during the burn itself, since it's reacting to the same diurnal RH swing your crew is standing in.
1000-hour fuels: the season you're burning into
1000-hour fuels run 3 to 8 inches, the chunky down wood and the bigger slash piles. These take a month or more to equilibrate, so a single dry week barely touches them. What moves 1000-hour moisture is the cumulative dryness of the season: how many consecutive dry days have stacked up, how deep the drought signal runs, whether the spring green-up recharged the big fuels before the dry season locked in.
This is also the class that does most of the lifting in Energy Release Component. ERC burn window guidance for a unit is really a read on 1000-hour moisture trending alongside live fuel moisture, which is why ERC climbs slowly through a dry summer and doesn't crash back down after one rain event the way a 1-hour or 10-hour number would. When a burn boss asks whether a unit has crossed the point where it can still carry a prescribed fire without torching the big material, 1000-hour moisture is the number that answers it. It's also the number that tells you whether a pile is going to hold smoke and smolder for a week after the crew signs off.
Reading them together on a prescription
A unit can show acceptable 100-hour moisture, meaning the surface fuels will carry fire the way you want, while 1000-hour moisture sits low enough from a dry summer that any large down wood on site burns hot and holds heat long after the flame front passes. That combination is exactly the one that produces a clean-looking burn day followed by a holdover call three nights later. Reading the two time-lag classes side by side, not just checking whether either one clears the prescription threshold, is what separates a plan on paper from a plan that matches what's actually sitting in the unit.
Moisture data on its own doesn't tell you how much fuel is loaded across the unit or how it's structured by strata, and that's the other half of the prescription math. Fuel Load Mapping fills that gap with an annual fuel-model layer built from high-resolution imagery, classifying canopy structure across a planning unit so you can pair current moisture readings against this year's canopy structure instead of a map pulled before the last drought cycle. If your unit's fuel model predates that last cycle, it's worth seeing what the current canopy structure looks like before you set the next prescription.